What the Maintenance Agreement Covers

The RP Power Maintenance Agreement is the trouble-free way to ensure that your standby generator system will take care of you in a power emergency. Under this agreement, our authorized, factory-trained technicians will perform the following tests and inspections using NFPA 110 suggested maintenance schedules as they apply to your system:

Fuel System

  • Check Fuel Levels in Day/Main Tank(s)
  • Test Transfer Pump Operation
  • Test for Water and Contaminants
  • Inspect Hoses, Piping and Connections

Lubrication System

  • Check Oil Level
  • Change Oil and Filter
  • Inspect and Clean Crankcase Breather

Cooling System

  • Check Coolant Level
  • Test Protection Level
  • Inspect Radiator Condition
  • Inspect Fan Belt(s)
  • Inspect Condition of Hoses and Piping
  • Test Jacket Water Heater
  • Inspect Ductwork, Louvers and Controls

Exhaust System

  • Check for Leaks
  • Drain Condensation Trap
  • Inspect Hangers and Supports
  • Check Insulation
  • Check for Fire Hazards
  • Inspect Flexible Sections

Battery Systems

  • Clean and Tighten Battery Terminals
  • Check Electrolyte Level and Specific Gravity
  • Verify Charger Operation and Charge Rate

Electrical System

  • Conduct General Inspections
  • Inspect Wiring and Connections
  • Test Operation of Safeties and Alarms
  • Inspect Boxes, Panels and Cabinets
  • Inspect Circuit Breakers and Fuses

Engine

  • Perform General Inspection
  • Service Air Cleaner
  • Inspect Governor and Check Operation
  • Inspect Ignition System
  • Inspect Injection Pump

Generator

  • General Inspection
  • Check Voltage Regulator
  • Inspect Bearing(s) and Grease if Necessary

Automatic Transfer Switch (ATS)

  • Perform General Inspection
  • Test Time Delays
  • Test ATS Options
  • Check Exercise Clock for Proper Operation

General Inspection of EPSS

  • Check for Vibration, Leakage, Noise, Temperature or Deterioration

Functional Test

  • Record Running Time Meter Reading
  • Simulate Normal Power Failure
  • Check TDES
  • Transfer Load to Generator
  • Record AC Voltage, Amperage and Frequency
  • Record Oil Pressure and Battery Charge Rate
  • Restore Normal Power to Allow Minimum Run Time of 30 Minutes
  • Record TDEN
  • Record TDEC
  back
back
back
back
         
         
   

| home | products | service | contact | about | powerpro | news | terms of use |

©2003-2007  RP Power, LLC    All Rights Reserved